Step 2 Opening Computer Case

Opening Computer Case

I received all of my parts on time and I unpacked and checked every box to make sure that there was no damage to any of the computer parts. I set up all of my parts on a spare table and now I am ready to build my computer.

Note: When installing computer hardware always unplug the power supply and all peripherals connected to the computer. Also use caution because there are sharp edges in a computer system. It is a good idea to wear a static electricity discharge wristband. The discharge strap will avoid damaging the components in the computer. Some other tools that might be needed are a non magnetic screwdriver, a pair of tweezers and an anti-static bag.

Taking the side panels off:

• There are many different types and styles of computer cases on the market today. Most computer cases open with a unlock lever or have two fasteners or screws holding both of the side panels on. The computer case I am using has 4 screws holding both side panels on (Two Screws for each side). In my computer case, I will need to remove the four screws with a screwdriver and then using my hand, apply pressure to the side of the case and pull back. I will repeat this process for both sides. The sides of the case should pull back and unclip. Now I can pull the side panels away from the computer case.

Computer case


Screw holding the side Panel


Unscrewing the side Panel


Apply Pressure to the side of the case


Pull back while the pressure is applied

Removing the front panel:
Once I have the side panels removed I have to remove the front panel. Front panels come off in a variety of fashions. Sometimes they use screws, fasteners or clips. The case I am using has four fasteners holding the front panel to the case. By squeezing the fasteners together I am able to unclip the front panel from the case.

Computer Case with side Panels off


Fastener that holds the Front Panel to the Case


The Front Panel Removed from the Computer Case